Note: Remove five screws 1 and four spring screws 2.
Unplug the connector in the direction shown by arrow 3.
When installing: Make sure that the fan connector is attached firmly to the system board.
Lift the fan assembly and heat sink assembly in the direction shown by arrow 4. Be careful not to damage the connector.
Attention: Do not handle the heat sink assembly roughly. Improper handling can cause distortion or deformation and imperfect contact with components.
When installing:
•• Before you attach the lenovo z560 / z565 cpu cooling fan assembly to the computer, apply thermal grease, at an amount of 0.2 grams, to the part shown in the figure above. Either too much or too less grease application can cause a thermal problem due to imperfect contact with a component.
•• In models with the discrete graphics chip, there is an additional thermal rubber whose film to be peeled off.
Reverse the procedure to install you new Lenovo z560 / z565 series laptop cpu cooling fan.